VWIC-2T1/E1-RAN

Model:VWIC-2T1/E1-RAN Router Multiflex Voice/WAN interface Card
Detail:2-Port RJ-48 T1/E1 Protection Switching RAN/ITP/SLT WIC
Guaranteed safe & secure checkout
Description
Reviews (0)
Q & A

Warranty: supplied with the Green Code 1-year standard hardware repair warranty. Any manufacturer warranty terms shown in the specifications below are the manufacturer’s own.

VWIC-2T1/E1-RAN is a WAN interface card for Cisco routers: 2-Port RJ-48 T1/E1 Protection Switching RAN/ITP/SLT WIC.

The three things that decide whether a card like this will work, in order of how often they are got wrong. First the chassis: a card seats mechanically in families it is not supported in, and on some platforms it will be recognised and then refuse to pass traffic. Second the software release, because card support is gated by release and a router held back on an older version will reject hardware that is otherwise perfectly compatible — the symptom looks like a hardware fault and is not one. Third the slot, because high-throughput cards often require specific slots with the fabric bandwidth to feed them, and the chassis will not tell you that until the card is in.

Three questions worth answering before any router purchase, whatever the model. What the throughput requirement actually is with your feature set enabled, rather than the datasheet figure measured without it. Whether the features you need are licensed as well as present, since on most platforms security and performance are separate entitlements. And how many slots or ports you will need in three years, because adding capacity is cheap and replacing a chassis is not.

Tell us the chassis, the software release it is running and which slot you intend, and we will confirm this card is supported in that combination before you order. If you are buying it as a spare, the part number on the card already fitted is a better guide than the original order paperwork, which on a router that has been maintained for a few years has usually drifted.

Green Code Technologies is a supplier of Cisco, and we supply Huawei and Juniper networking alongside HPE, Dell, Samsung, Netgear, Ubiquiti and Asus. We would rather tell you a part is no longer supported, or that we need to check it, than take an order for something that will not do what you need.

VWIC-2T1/E1-RAN

Manufacturer

Cisco

Part Number

VWIC-2T1/E1-RAN

Device Type

Interface module

Form factor

Cisco 2-Port T1/E1 Protection Switching RAN VWIC

Specifications

Feature

• Two independent T1/E1 or fractional T1/E1 ports with RJ-48C physical connectors

• Software-configurable T1/E1 mode

• T1/E1 interface loopbacks, 75- and 120-ohm impedances (balanced and unbalanced), framing (SF and ESF), and line codes (AMI, B8ZS, HDB3); support for E1 structured and unstructured operation

• LEDs for data carrier detect (DCD), loopback (LP), and alarm (AL)

Dimensions (H x W x D)

0.8 x 3.1 x 4.8 in. (2.1 x 7.9 x 12.2 cm)

Weight

0.12 lb (56 g) minimum, 0.18 lb (81 g) maximum

Operating Temperature

-10 to +55°C (14 to 131°F)

Storage Temperature

-40 to 85°C (-40 to 185°F)

Relative Humidity

5 to 90% noncondensing, ±5%

DSU/CSU

• Selectable DSX-1 cable length in increments from 0 to 655 ft in DSU mode

• Selectable DS-1 CSU line build-out: 0, -7.5, -15, and -22.5 dB

• Selectable DS-1 CSU receiver gain: 26 or 36 dB

Diagnostics

• ANSI T1.403 Annex B/V.54 loopup/down code recognition, network loopback, user initiated loopbacks, network payload loopback, local DTE loopback, remote line (codes: V.54, loop up, and loop down)

• BERT patterns all 0’s, all 1’s, 1:2, 1:8, 3:24, QRW, QRSS, 63, 511, 2047, and V.54/T1.403 Annex B bit patterns; two user-programmable 24-bit patterns

• Alarm detection: Alarm indication signal (AIS), time slot 16 AIS, remote alarm, far-end block error (FEBE), out of frame (OOF), cyclic redundancy check (CRC) multiframe OOF, signaling multiframe OOF, frame errors, CRC errors, loss of network signal (red alarm), loss of network frame, receive (blue alarm) (AIS) from network, receive (yellow) from network performance reports/error counters CRC, errored seconds, burst errored seconds, severely errored seconds, Ft and Fs framing errors for SF framing, FPS framing errors for ESF framing, 24-hour history stored in 15-minute increments

• Onboard processor for real-time facility data link (FDL) messaging, in-band code detection and insertion, alarm integration, and performance monitoring

• Full FDL support and FDL performance monitoring, according to configurable standard: ANSI T1.403 or AT&T TR 54016

Reviews

There are no reviews yet

Be the first to review “VWIC-2T1/E1-RAN”

Your email address will not be published. Required fields are marked *

Q & A

Ask a question
There are no questions yet
Why Choose Us

Trusted IT Hardware,
Delivered Right.

Green Code Technologies is a UK-based IT hardware supplier trusted by businesses across 50+ countries — for genuine equipment, worldwide delivery, and expert support.

Enterprise IT Solutions Partner

Genuine, warranty-backed hardware from leading brands including Cisco, Huawei, HPE, Dell, Fortinet and more.

UK & Worldwide Delivery

We deliver across the UK and export worldwide. Lead times vary by product and are confirmed at quotation.

100% Authentic Hardware

Every product is verified for authenticity with verifiable serial numbers. We supply only genuine and certified equipment.

Expert Technical Support

Our in-house engineers provide free pre-sales and post-sales support to help you choose the right product for your infrastructure.

Competitive Pricing

We work to bring you the best enterprise IT hardware value without compromising on quality or warranty.

Sustainable IT Solutions

Sustainability is at our core. We offer eco-friendly certified-refurbished options alongside new hardware to reduce your organisation's carbon footprint.

10,000+ Products Listed
50+ Countries Served
1-Year Standard Repair Warranty