PWR-C45-6000ACV
| Model: | PWR-C45-6000ACV Cisco Catalyst 4500 PoE Enabled Power Supply |
| Detail: | Cisco Catalyst 4500 Power Supply PWR-C45-6000ACV Catalyst 4500 6000W AC dual input Power Supply (Data + PoE) |
Warranty: supplied with the Green Code 1-year standard hardware repair warranty. Any manufacturer warranty terms shown in the specifications below are the manufacturer’s own.
Cisco PWR-C45-6000ACV is a Catalyst 4500 6000W AC dual input Power Supply (Data + PoE). It belongs to the Catalyst 4500 PoE Enabled Power Supply range. Matching on sight is unreliable here. The part number is what determines whether it will work in a given chassis.
Size it for the load, not the box. The common mistake is choosing a supply that covers the chassis and forgetting everything hanging off it. On a PoE switch the powered devices draw through the same supply, and a fully loaded access switch can need several times the chassis figure. Check the input type against the rack, and match airflow direction if a second unit is going in alongside.
How we supply it. Supplied new where available, otherwise as tested stock with warranty, subject to availability. Quote the equipment it is for when you ask and we will verify the fit first.
PWR-C45-6000ACV Specification | |
AC-input type | Autoranging inputs with power factor correction Note Power factor correction is a standard feature on all Catalyst 4500 E-series AC-input power supplies. PFC reduces the reactive component in the source AC current allowing higher power factors (typically 99 percent or better) and lower harmonic current components. |
AC-input voltage | Low-line (120 VAC nominal)—85 VAC (min) to 132 VAC (max) High-line (230 VAC nominal)—170 VAC (min) to 264 VAC (max) |
AC-input current | 12 A (max) @ 120 VAC (for each input) 16 A (max) @ 230 VAC (for each input) |
AC-input frequency | 50/60 Hz (nominal) (±3% for full range) |
Power supply output | Total output depends on the number of inputs connected and the source AC voltage. If two inputs are used, they should both be of the same AC voltage. 1050 W operation (with one 120 VAC nominal input) – 70.8 A @ 12 VDC (data only) – 12.5 A @ 3.3 VDC (data only) – 18.4 A @ –50 VDC (PoE if used) 2100 W operation (with two 120 VAC nominal inputs) – 141.6 A @ 12 VDC (data only) – 12.5 A @ 3.3 VDC (data only) – 37.0 A @ –50 VDC (PoE if used) 3000 W operation (with one 230 VAC nominal input) – 183.3 A @ 12 VDC (data only) – 12.5 A @ 3.3 VDC (data only) – 48 A @ –50 VDC (PoE if used) 6000 W operation (with two 230 VAC nominal inputs) – 183.3 A @ 12 VDC (data only) – 12.5 A @ 3.3 VDC (data only) – 96 A @ –50 VDC (PoE if used) |
Power supply output capacity | 6000 W maximum |
Output holdup time | 20 ms minimum |
kVA rating5 | 6.8 kVA (power factor = 0.99) |
Heat dissipation | 2,720 BTUs/hr (approx.) |
Minimum software requirement | Cisco IOS Release 12.2(52)SG |
Power over Ethernet | Supported, up to 4800 W |
LEDs and Meanings | |
INPUT OK | Green—Source AC voltage is OK. (Input voltage is 85 VAC or greater.) Off—Source AC voltage falls below 70 VAC, is not present, or the power supply is turned off. |
FAN OK | Green—Power supply fan is operating properly. Off—Power supply fan failure is detected. |
OUTPUT FAIL | Red—Problem with one or more of the DC-output voltages of the power supply is detected. Off—DC-output voltage with acceptable margins. Note For proper operation of the OUTPUT FAIL LED, systems with single power supplies must be configured with a minimum of one fan tray assembly and one supervisor engine. Systems with dual power supplies must have a minimum configuration of one fan tray assembly, one supervisor engine, and one additional module. Failure to meet these minimum configuration requirements can cause a false power supply output fail signal. |
Q & A
Trusted IT Hardware,
Delivered Right.
Green Code Technologies is a UK-based IT hardware supplier trusted by businesses across 50+ countries — for genuine equipment, worldwide delivery, and expert support.
Enterprise IT Solutions Partner
Genuine, warranty-backed hardware from leading brands including Cisco, Huawei, HPE, Dell, Fortinet and more.
UK & Worldwide Delivery
We deliver across the UK and export worldwide. Lead times vary by product and are confirmed at quotation.
100% Authentic Hardware
Every product is verified for authenticity with verifiable serial numbers. We supply only genuine and certified equipment.
Expert Technical Support
Our in-house engineers provide free pre-sales and post-sales support to help you choose the right product for your infrastructure.
Competitive Pricing
We work to bring you the best enterprise IT hardware value without compromising on quality or warranty.
Sustainable IT Solutions
Sustainability is at our core. We offer eco-friendly certified-refurbished options alongside new hardware to reduce your organisation's carbon footprint.



























Reviews
There are no reviews yet